Synergy 8024-30/8024-40 - JK Synergy Stage 4 Long Arm System - Manual (Page 6)

f) Remove the threaded inserts for the transmission skid plate. These are located on
the bottom of the frame just to the rear of the stock lower control arm brackets.
Thread the skid plate bolts into the threaded inserts so there is about a ½” of
thread showing. Strike the head of the bolt upward with a large hammer to break
the threaded insert loose from the frame. Remove the threaded insert and bolt.
g) Clean and paint the frame where the control arm brackets were removed
6. INSTALL NEW FRONT LONG ARM CONTROL ARM BRACKETS
a) Insert the lower nut tab in the frame