Snorkel LX50-sn2747-3299 - Manual (Page 2)

N EVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs,
bumps and debris.
N EVER operate the machine if all guardrails are not properly in place and secured with all fasteners properly torqued.
S ECURE and lock gate after mounting platform.
K EEP all body parts clear of outriggers when extending or retracting (outrigger equipped machines only).
N EVER use ladders or scaffolding on the platform.
N EVER attach overhanging loads or increase platform size.
M AINTAIN tire pressure at 50 psi (LX31/41).
L OOK up, down and around for overhead obstructions and electrical conductors.
D ISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
N EVER use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back cover.)
N EVER change operating or safety systems.
I NSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control cable, loose
wire connections and wheel bolts.
N EVER climb down elevating assembly with the platform elevated.
N EVER perform service on machine while platform is elevated without blocking elevating assembly.
N EVER recharge battery near sparks or open flame; batteries that are being charged emit highly explosive hydrogen
gas.
A FTER U SE secure the work platform against unauthorized use by turning key switch off and removing key.
N EVER replace any component or part with anything other than original UpRight replacement parts without the man-
ufacturer's consent.
N EVER
operate the machine within
ten feet of power lines. THIS
MACHINE IS NOT INSULATED.
N EVER elevate or drive elevated
on uneven slopes or soft ground
or elevate the platform unless the
platform is level.
N EVER sit, stand or climb on
guardrail or midrail.
English Language Section
Safety Rules
NOTES:
2 43