Advance Adapters AX15 - Manual (Page 22)

22
P/N 712555 adapter plate
& retainer installed.
JEEP 4 CYL. ENGINE WITH A NP231 NV4500 KITS JEEP 4 CYL. ENGINE WITH A NP231 NV4500 KITS JEEP 4 CYL. ENGINE WITH A NP231 NV4500 KITS JEEP 4 CYL. ENGINE WITH A NP231 NV4500 KITS JEEP 4 CYL. ENGINE WITH A NP231 NV4500 KITS
(AX5 REPLACEMENT) (AX5 REPLACEMENT) (AX5 REPLACEMENT) (AX5 REPLACEMENT) (AX5 REPLACEMENT)
P/N 27-0019T - 29 spl. DODGE Gas NV4500 to Jeep 4 cylinder Adap. plate design (AX5 replacement)
The overall assembly length is 25.625”. This kit is designed around the 1989-93
Jeep with the internal release bearing. If your AX5 has the external slave
cylinder, we can switch the bellhousing adapter plate kit to accommodate
the 1994 & later slave cylinder configuration. Our adapter plate will permit the
NV4500 to bolt directly to the original bellhousing. The original slave cylinder configuration
on this conversion is retained and a special Centerforce clutch disc will be required
(Part
No. 383824) . Driveline modifications will be required when retaining the original 4 cylinder
engine. Due to the added length a fixed yoke kit (P/N 50-7906) is highly recommended.
When coupled to the Peugeot or AX5, the stock transfer case used a 21 spline input gear.
A new input gear must be installed to match the output spline of your transmission.
NOTE:
These new gears will only fit the NP231 transfer case, and the transfer case must be
disassembled for installation of this input gear.
The transfer case adapter is the shortest design possible to couple to the New Process transfer case. This adapter comes with
a shifter bracket that allows the use of your stock transfer case shifter. These packaged kits include a new support crossmember
which couples to the stock skid pan. Modifications will be required to your floorboard for the shifters and the skid pan will require
new holes to be drilled for our crossmember support. A body lift is normally recommended for clearance.
These kits include: These kits include: These kits include: These kits include: These kits include:
P/N 50-0204 - Transfer case adapter kit
P/N 712555 - Adapter plate kit
P/N 716008 - Crossmember mount
P/N 716050D1 - Shifter handle assembly
P/N 50-0231 - 29T NP231 T/C input gear
Regarding P/N 712555 adapter plate to Jeep AX5 bellhousing (internal release bearing only) : In order to adapt the Dodge
Standard Duty NV4500 to a Jeep AMC 4 cylinder engine, we found it necessary to adapt directly to the original AMC bellhousing.
We have designed this adapter plate to bolt to the NV4500, providing the correct bolt pattern and dowel pins for the stock AX5
bellhousing. This kit requires you to remove and modified your NV4500 front bearing retainer, then install it on the front of the
NV4500 transmission. With the adapter plate and retainer installed, the front of the NV4500 is an exact image of the stock AX5
transmission. The stock internal release bearing should be replaced with Jeep Part# 83503384. A new pilot bushing is provided
in the kit to fit the tip of the NV4500 input shaft. A new 1-1/8” 10 spline clutch disc is required. We offer this Centerforce clutch disc
as
P/N 383824 . The stock pressure plate for the 4 cylinder is retained; however, a new one should be used.