Advance Adapters AX15 - Manual (Page 25)

25
P/N 716130 P/N 716130TJ
Transfer case shifter bracket
When fitting the NV4500 into a Jeep TJ, the stock console creates
a challange to fit the handle in the correct location. We’ve found
that the modifications to the handle as shown here is a easy way
to keep the Jeep console looking like stock.
NV4500 handle location (6 cyl. TJ)
floorboard for the shifters, and the skid pan will require new holes to be drilled for our crossmember support. A body lift is normally
recommended for clearance. Due to the different transfer case shift controls found on Jeep Cherokees, this kit should not be used
with these vehicles.
These kits are also supplied with a new external slave cylinder. When coupling this new slave cylinder to your stock master cylinder,
you will be required to use one of the following clutch fittings,
P/N 716130 or 716130TJ . The correct fitting will depend on which
configuration you have on your stock master cylinder fitting (fittings are shown below).
This kit include: This kit include: This kit include: This kit include: This kit include:
P/N 50-0204 - Transfer case adapter kit
P/N 712568 - Bellhousing kit
(For clutch components, refer to the AMC
Full Bellhousing subheading at the end of this section)
P/N 716008 - Crossmember mount
P/N 716331 - Jeep slave cylinder kit
P/N 716050D1 - Shifter handle assembly
P/N 716130H - Slave cylinder hose
P/N 50-0231 - 29 Spline input gear
(TJ optional transfer case bracket) P/N 715542 can be substituted for P/N 715531 which is part of the transfer case adapter kit.
The use of this bracket may require some casting modifications.
This kit is designed for our NV4500 transmis-
sion P/N 26-0029RGM. If you are obtaining
your own transmission, you will need to order
a new input shaft to work with the bellhousing.
P/N 52-0221 - GM input shaft.