Advance Adapters AX15 - Manual (Page 45)

45
TOYOTA TRUCK 4 CYLINDER:
If you wish to retain your 4 cylinder, we have listed the components designed to couple the NV4500 the the stock 4 cylinder. These
parts are designed to work with a
1996 & Newer GM 4WD NV4500 transmission. This adapter plate works in conjunction
with your stock 4 cylinder bellhousing and clutch linkage. This kit requires the use of a stock Toyota 4 cylinder
bellhousing (tranny codes G52, G54 W56 & G58). Vehicles 1979-83, have an integral (one piece) bellhousing and require
the use of a late model bellhousing and slave cylinder.
The bellhousing adapter kit comes with a new 1-1/8” clutch disc for the stock Toyota bellhousing. The transfer case adapter supplied
in this kit is for the 21 spline Toyota transfer case. If you are going to use a 23 spline transfer case, you can substitute the transfer
case adapter for
P/N 50-0216 . When doing this conversion, you should anticipate driveline modifications along with
crossmember support repositioning. The shifter handle location on the NV4500 is 10.375” from the front of the transfer case, which
will require some floorboard modifications. The overall assembly length is
26.360” .
GM 4WD NV4500 to Toyota 4 cyl. (1979-95)
P/N 712556 - Adapter plate kit
P/N 50-0215 - Transfer case adapter (21 spline)
P/N 716050C - Shifter handle assembly
Regarding P/N 712556 adapter kit to Toyota 4WD truck (G52, G54, W56 & G58) bellhousing:
In order to adapt a 1996 & up GM 4WD NV4500 to the stock 4 cylinder engine, an adapter plate is necessary. Our adapter plate
works in conjunction with your stock 4 cylinder bellhousing and clutch linkage. A new clutch disc is included in this kit. The kit
does require you to remove and modify the front bearing retainer. The stock Toyota front retainer must be retained and mounted
to the adapter plate in this kit.