IKA KS 4000 ic control - Manual (Page 29)

29 KS 4000 i 1011
approved by IKA to clean IKA devices.
To remove use:
Dyes
isopropyl alcohol
Construction materials water containing tenside / isopropyl alcohol
Cosmetics
water containing tenside / isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
For materials which are not listed, please request information
from IKA. Wear the proper protective gloves during cleaning of
the devices.
Electrical devices may not be placed in the cleansing agent for
the purpose of cleaning.
Before using another than the recommended method for clea-
ning or decontamination, the user must ascertain with the
manufacturer that this method does not destroy the instru-
ment.
Collecting tray with drain hose (for picture see below)
(applies to KS4000 i control and KS4000 ic control)
In the event of glass breakage, leaking liquid is collected by the
collecting tray below the shaking table and guided to the drain
hose via a drain at the rear.
1. Remove drain hose
from bracket
2. Place drain hose
in laboratory drain
Cleaning of the collec-
ting tray:
- four countersunk
head screw at the
top side of the
shaking table
loosen
- shaking table
upward remove
Cleaning the Plexiglas cover:
- Do not dry wipe.
- Do not use abrasive materials.
- Do not use solvents.
Clean dusty surfaces with warm water, detergent and a soft
cloth.
We recommend the anti-static plastic cleaner “AKU” by Burnus
GmbH, Darmstadt.
For disinfecting, only use products prescribed by the manufac-
turer specially for use on Plexiglas.