Brother PE-DESIGN V7 - Manual (Page 306)

300
Tutorial (Advanced)
Click (Manual Punch tool).
Click (straight block-type pattern),or
use shortcut “z” on your keyboard.
Click in the Design Page to specify points 8
through 10.
Click (Manual Punch tool).
Click (Running-type pattern button),or
use shortcut “v” on your keyboard.
Click (Manual Punch tool).
Click (straight block-type pattern),or
use shortcut “z” on your keyboard.
Click in the Design Page to specify points 11
through 12.
Double-click point 13 (the last point of the
entire pattern).
Click .
Drag SetLine to adjust the character width.
b
Memo:
By clicking (Running-type pattern
button) at this point, overlapping stitching can
be prevented.
8
9
10
b
Memo:
To remove the last point that was entered,
click the right mouse button.
11
12
13
Set Line Set Line