Eppendorf FemtoJet - Manual (Page 55)

53
Appendix A
Other error numbers as well as the error cause and solution are described
in Section 5, "Troubleshooting". During remote control, no error texts
appear in the FemtoJet

display.
Error no.
during
execution ERR
= [eee] Cause Solution
070 FemtoJet

is not in routine
mode.
Check FemtoJet

.
Bring FemtoJet

into
routine operation.
Eliminate error.
071 FemtoJet

is not ready. Check FemtoJet

or
micromanipulator.
As necessary, wait or
eliminate error.
072 The command is not finished
within the scheduled time. Check FemtoJet

or
micromanipulator.
Eliminate error.
073 This command cannot be
executed at the moment,
because of insufficient storage
pressure.
See: Warning 001 Check FemtoJet

.
Eliminate error.
074 The connected micro-
manipulator did not respond.
See: Warning 003 Check micro-
manipulator.
Eliminate error.
A_Bedien_Computer_en.fm Seite 53 Mittwoch, 27. September 2006 5:26 17