Eppendorf Mastercycler pro - Manual (Page 40)

Operation
Mastercycler pro
English (EN)
40
The New Cycler Program window is displayed. You can enter a name and a comment for the new
program using the numerical keys here.
3. Press the OK function key.
The program is created and appears under your user node.
5.5.2 Copying folders and programs
You can copy folders and programs to your own user nodes as follows. When copying a folder, the
programs it contains are also automatically copied.
1. In the user node belonging to any user, mark the folder or the program you want to copy.
2. Press the Copy function key.
A message appears informing you that the folder or the program was copied to the clipboard.
3. Confirm the note with OK .
4. Mark your own user node. If you want to copy a single program, you can also select a folder below your
user node to which you want to insert the program.
5. Press the Paste function key.
If a program or folder already exists with the same name, you will be prompted to enter a new name.
The folder or program is inserted under your user node. You can now start or edit this program.
5.5.3 Deleting folders and programs
1. In the navigation tree, mark the folder or the program.
2. Press the Delete key.
A confirmation prompt appears.
3. Confirm confirmation prompt with Yes .
The folder or program is deleted.
You can change the name of the program or the comment at any time using the Prop. function
key.
To protect a program against inadvertent changes, you can use the Prop. function key to mark
it as write-protected ( read only ). This means the program can then be displayed in the
program editor(see p. 41), but not changed. This is recommended when working without a
PIN.