JLG 660SJ Operator Manual - Manual (Page 32)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-12 – JLG Lift – 3121297
General
Begin the "Walk-Around Inspection" at Item 1, as noted on
the diagram. Continue checking each item in sequence for
the conditions listed in the following checklist.
TO AVOID POSSIBLE INJURY BE SURE MACHINE POWER IS OFF.
INSPECTION NOTE: On all components, make sure there
are no loose or missing parts, that they are securely fas-
tened, and no visible damage, leaks or excessive wear
exists in addition to any other criteria mentioned.
1. Platform Assembly and Gate - Footswitch works prop-
erly, not modified, disabled or blocked. Latch and
hinges in working condition.
2. Platform & Ground Control Consoles - Switches and
levers return to neutral, decals/placards secure and
legible, control markings legible.
3. Rotator - See Inspection Note.
4. Jib (If Equipped) - See Inspection Note.
5. Power Track - See Inspection Note.
6. All Hydraulic Cylinders - See Inspection Note.
7. Drive Motor, Brake, and Hub - See Inspection Note.
8. Wheel/Tire Assemblies - Properly secured, no missing
lug nuts. Inspect for worn tread, cuts, tears or other
discrepancies. Inspect wheels for damage and corro-
sion.
9. Tie Rod and Steering Linkage - See Inspection Note.
10. Turntable Lock - Operable.
Figure 2-4. Daily Walk-Around Inspection Points - Sheet 1 of 2