JLG 660SJ Operator Manual - Manual (Page 48)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-14 – JLG Lift – 3121297
NOTE: The Drive joystick is spring loaded and will automatically
return to neutral (off) position when released.
9. Drive/Steer
Push forward to drive forward,
pull back to drive in reverse.
Steering is accomplished via a
thumb-activated rocker switch
on the end of the steer handle.
10. Telescope
Provides extension and retraction of the
main boom.
11. Lights (If Equipped)
This switch operates control console panel
lights and head lights if the machine is so
equipped. The ignition switch does not have to be on to
operate the lights, so care must be taken to avoid drain-
ing the battery if left unattended. The master switch and
/ or the ignition switch at the ground control will turn off
power to all lights.
12. Jib (If Equipped)
Push forward to lift up, pull back to lift
down. Variable lift speed is using the Func-
tion Speed Control.
13. Soft Touch Override Switch (If
equipped)
This switch enables the functions that
were cut out by the Soft Touch system to operate again
at creep speed, allowing the operator to move the plat-
form away from the obstacle that caused the shutdown
situation.
14. Soft Touch Indicator (If Equipped)
Indicates the Soft Touch bumper is
against an object. All controls are cut
out until the override button is pushed, at which time
controls are active in the Creep Mode.