Hd30/hdp20 series disassembly, Hd30/hdp20 series disassembly -11, Hd/hdp locking contacts into position -11 – JLG 3248RS/10RS Service Manual User Manual

Page 137: Hd/hdp contact removal -11, Hd/hdp unlocking contacts -11

Advertising
background image

SECTION 7 - GENERAL ELECTRICAL INFORMATION & SCHEMATICS

3121273

– JLG Lift –

7-11

10. Push contact straight into connector grommet until a positive stop is felt. A slight tug will confirm that it is properly

locked in place.

Figure 7-15. HD/HDP Locking Contacts Into Position

NOTE: For unused wire cavities, insert sealing plugs for full environmental sealing

HD30/HDP20 Series Disassembly

Figure 7-16. HD/HDP Contact Removal

11. With rear insert toward you, snap appropriate size extractor tool over the wire of contact to be removed.

12. Slide tool along into the insert cavity until it engages contact and resistance is felt.

13. Pull contact-wire assembly out of connector.

Figure 7-17. HD/HDP Unlocking Contacts

NOTE: Do Not twist or insert tool at an angle.

Advertising
This manual is related to the following products: