JLG 450AJ ANSI Operator Manual - Manual (Page 29)

SECTION 2 - PREPARATION AND INSPECTION
3120748 – JLG Lift – 2-13
18 Air Filter - Deutz Replaceable
Element
N/A N/A X Or as indicated by condition indicator
19 Air Filter - Isuzu Replaceable
Element
N/A N/A X Or as indicated by condition indicator
NOTES: KEY TO LUBRICANTS
Lubrication intervals are based on machine operation under normal conditions. For machines used in multi shift operations and/or exposed to hostile envi-
ronments or conditions, lubrication frequencies must be increased accordingly. EO
EPGL
HO
MPG
OGL
Engine Oil
Extreme Pressure Gear Lube
Hydraulic Fluid (Mobil DTE-11M)
Multi-Purpose Grease
Open Gear Lubricant - Mobiltac 375 or
equivalent
* If necessary install grease fittings into worm gear housing and grease bearings.
DO NOT OVERGREASE BEARINGS. OVERGREASING BEARINGS WILL RESULT IN
BLOWING OUTER SEAL IN HOUSING.
**When changing oil in the Deutz oil cooled engine, drain both the crankcase and the cooler. When refilling it is acceptable to overfill crankcase (11.3 qts.
[10.5 L], capacity of both crankcase and cooler combined). Start engine, allow the engine to run until the thermostat opens (approximately 221 degrees F)
cooler will fill up within minutes; shut down and wait for approximately two minutes. Check oil level, fill oil to max marking on dipstick.
Table 2-1. Lubrication Chart
Components
Number/Type
Lube Points
Capacity Lube
Interval Hours
Comments
3
Months
150 hrs
6
Months
300 hrs
1 Year
600 hrs
2 Years
1200 hrs
Updated 11-8-99