JLG 450AJ ANSI Operator Manual - Manual (Page 45)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3120748 – JLG Lift – 3-15
WARNING
!
WARNING
!
DANGER
!
DO NOT replace items (i.e., Batteries, tires, counterweight, etc) with items of different weight
or specification because this will affect the stability of the machine.
DO NOT modify or change this machine without written approval from the manufacturer.
Read and understand decals and placards.
Check all functions at ground control and platform control stations. Select an area free of obstructions.
Refer to the JLG Operation and Safety Manual for further daily/ frequent/ annual checks and the walk around inspection.
Make sure all tires are in good condition and air filled tires are properly inflated.
Operate this machine with extreme caution. STOP all operation if a malfunction occurs.
If this machine is not properly maintained, death or serious injury could occur. DOM 1703798
THIS MACHINE MUST NOT BE USED UNTIL IT IS
INSPECTED AND OPERATING PROPERLY.
CRUSHING HAZARD
Failure to follow these instructions could
result in death or serious injury.
ELECTROCUTION HAZARD
This machine is not insulated.
Maintain a clearance of at least 10 ft. between any part of machine
or load and any electrical line or apparatus charged up to 50,000 volts.
One foot additional clearance is required for each additional 30,000
volts or less.
Allowances must be made for operator error, machine deflection and
electrical line swaying.
Death or serious injury will occur from contact or being
too close to electrical lines.
DO NOT operate this machine unless you have been properly trained as described in the JLG Operation and Safety
Manual by a qualified person and authorized to operate this machine. Your training includes reading and understanding
the safety, operating and maintenance instructions in manufacturer’s manuals, knowing your employers work rules and
applicable governmental regulations.
Personnel shall not position themselves or other objects UNDER boom
and platform or BETWEEN boom and turntable or chassis.
When operating from ground control station avoid being BETWEEN
rotating superstructure and chassis or other immovable objects.
DANGER
!
ELECTROCUTION HAZARD
Death or serious injury will occur from contact
or being too close to electrical lines.
This machine is not insulated.
Maintain a clearance of at least 10 ft. between any part of machine
or load and any electrical line or apparatus charged up to 50,000 volts.
One foot additional clearance is required for each additional 30,000
volts or less.
Allowances must be made for operator error, machine deflection and
electrical line swaying.
1703805 A
1703798 B
1703805 B