JLG 340AJ Operator Manual - Manual (Page 44)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-12 – JLG Lift – 3121258
Platform Control Indicator Panel
(See Figure 3-4., Platform Control Indicator Panel)
NOTE: The indicator lights will illuminate for approximately 1 sec-
ond when the key is positioned to the on position to act as
a self test.
1. AC Generator (If Equipped)
Indicates the generator is in operation.
2. Platform Overload Indicator (If Equipped)
Indicates the platform has been overloaded.
3. Tilt Alarm Warning Light and Alarm
This red illuminator indicates that the chassis is on a
slope. An alarm will also sound when the chassis is on a
slope and the boom is out of transport position. If lit
when boom is out of transport position, lower to below
horizontal then reposition machine so that it is level
before continuing operation. If the boom is above hori-
zontal and the machine is on a slope, the tilt alarm warn-
ing light will illuminate and an alarm will sound and
CREEP is automatically activated.
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR
EXTENDED, RETRACT AND LOWER TO BELOW HORIZONTAL THEN
REPOSITION MACHINE SO THAT IT IS LEVEL BEFORE EXTENDING
BOOM OR RAISING BOOM ABOVE HORIZONTAL.
Tilt Angle Market
3° CE & Australia
5° ANSI, CSA & Japan