JLG 510AJ Operator Manual - Manual (Page 123)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121179 – JLG Lift – 6-41
6. Remove the retainer clip for the LPG fuel temperature
sensor and remove the sensor from the regulator body.
NOTE: Have a small container ready to collect oil that will drain
freely from the regulator at this point.
7. Once all of the oil has been drained, reinstall the LPG
fuel temperature sensor and reconnect the electrical
connector.
8. Open the fuel tank manual valve.
9. Start the engine and verify all connections are secure.
10. Dispose of any drained oil per local regulations in a safe
and proper fashion.
6.6 PROPANE FUEL FILTER REPLACEMENT
Removal
1. Relieve the propane fuel system pressure. Refer to Pro-
pane Fuel System Pressure Relief.
2. Disconnect the negative battery cable.
3. Slowly loosen the Filter housing and remove it.
4. Pull the filter housing from the Electric lock off assembly.
5. Remove the filter from the housing.
6. Locate Filter magnet and remove it.
7. Remove and discard the housing seal.
8. If equipped, remove and discard the retaining bolt seal.
9. Remove and discard mounting plate to lock off O-ring
seal.