Sample capacity chart (aus), Sample capacity chart (aus) -8, Warning – JLG 40xxPS Operator Manual User Manual
Page 88
Section 5 - Attachments and Hitches
5-8
31200205
Sample Capacity Chart (AUS)
Note: This is a sample capacity chart only! DO NOT use this chart, use the one
located in your operator cab.
WARNING
TIP OVER HAZARD. All loads shown on rated capacity chart are based on
machine being operated within the parameters indicated on the appropriate load
chart; proper size tires being properly inflated; and the telehandler being in good
operating condition.
OAH1072
REQUIRES FIRM SURFACE WITH LOAD ON FORKS.
LIFTING (STATIONARY)
LEVEL CHASSIS BEFORE LIFTING.
XXXXXXXXXX C
TRAVELLING (PICK & CARRY)
REQUIRES LOAD ON FORKS.
MAX TRAVEL WITH RATED LOAD 10 KM/H.
BOOM FULLY RETRACTED.
1. TYRE SIZES:
SPECIFICATIONS FOR SAFE USE
- XXXXX XXPLY XX PSI / X BAR.
2. IN-SERVICE WIND SPEED:
- XXM/S (XXKM/H).
3. GROUND CONDITIONS:
- FIRM SURFACES FOR LIFTING.
- SLOPE AND LOAD LISTED ABOVE FOR
BOTH CONFIGURATIONS.
4. STANDARD USED: (AS 1418.19-2007).
XXX MM LOAD CENTER.
X° MAX
X° MAX
XXXMM MAX
X° MAX
X° MAX
XXXMM
MAX
X° MAX
JLG XXXXXX
P/N XXXXXXX
P/N XXXXXXX
P/N XXXXXXX
P/N XXXXXXX
P/N XXXXXXX
7
8
9
10
11
12
13
0
1
2
3
4
5
6
7
8
9
14
XXXX kg
X
X
X
k
g
0
m
0°
10°
20°
30°
40°
50°
60°
70°
A
B
C
D
E
F
G
1
5
6
2
3
4
X
X
X
k
g
X
X
X
X
k
g
X
X
X
X
k
g
X
X
X
X
k
g
X° MAX
XXXMM MAX
Boom
Extension
Indicator
(arc)
Load zones indicate
the maximum weight
that may be safely lifted.
Boom
Angle
This Capacity Chart may be
used with this model ONLY.
The telehandler model is
indicated on the boom or chassis.
Model XXXX is used for
demonstration purposes only.
These numbers must match the
model/option number stamped
on the attachment ID Plate.
Lifting
Information
Traveling
Information
Specifications
For Safe Use