Disassembly, Disassembly -10 – JLG 660AJ Service Manual User Manual
Page 158
Advertising
SECTION 4 - BOOM & PLATFORM
4-10
– JLG Lift –
3121616
Disassembly
1.
Remove capscrews (113) over end cap lock pins (109).
2.
Using a 1/8” (3.18mm) drill bit, drill a hole in center of
each lock pin approximately 3/16" (4.76mm) deep.
3.
Remove lock pins using an ”Easy Out” (Size #2 shown. If
pin will not come out, use 5/16" drill bit 1/2" (12.7mm)
deep to drill out entire pin.
4.
Remove end cap (4) using tools provided with Helac seal
kit.
5.
Using a metal bar or similar tool, unscrew end cap (4) by
turning it counter clockwise.
6.
Remove end cap (4) and set aside for later inspection.
Advertising
This manual is related to the following products: