Replace moving end brackets, Replace moving end brackets -30 – JLG 660AJ Service Manual User Manual
Page 178
Advertising
SECTION 4 - BOOM & PLATFORM
4-30
– JLG Lift –
3121616
2.
Parts used: Bracket Center Pin and Center Pin Snap Ring.
3.
Take new bracket and install bracket center pin and
snap ring. Repeat on other bracket if replacing it.
NOTE: Ensure snap rings are seated in pin groove and closed
properly.
Replace Moving End Brackets
REPOSITION CABLES AND HOSES. KEEP COVERED DURING GRINDING TO PRE-
VENT DAMAGE.
1.
Remove existing pins and center rivet. Remove rivet as
shown in link removal instructions on page 4-20. Repeat
on other bracket if replaced.
Correct
Incorrect
Advertising
This manual is related to the following products: