JLG 150HAX ANSI Service Manual User Manual

Page 124

Advertising
background image

SECTION 5 - HYDRAULICS

5-28

– JLG Lift –

3120679

16.

Slip the thrust plate with seal over gear journals and
into the housing bore. The flat side of the seal
should face up with the relief groove facing the out-
let side.

17.

Position the bearing carrier over the gear housing so
the bushings receive the journals of the drive and
driven gears. Be sure to line up the dowel holes over
the dowel pins. When the parts are parallel, squeeze
them together or alternately tap over each dowel
until the parts are together.

18.

Insert the connecting shaft in the spline of the drive
gear. Position and place the second gear housing
on the bearing carrier as outlined in step 12.

19.

Place the thrust plate in the gear housing per step
14. Insert the drive and driven gears of the second
section in their respective bearings. Make sure the
gears are in contact with the thrust plate face. Place
the port end cover plate in the housing per step 16.

Advertising