JLG 150HAX ANSI Service Manual - Manual (Page 44)

SECTION 3 - CHASSIS & TURNTABLE
3-6 – JLG Lift – 3120679
l. Place spring (43) into spindle counterbore.
m. Set second spacer washer (42) on top of spring.
EYE PROTECTION SHOULD BE WORN DURING RETAINING RING
INSTALLATION.
n. Compress spacer washer and spring into spin-
dle counterbore and install retaining ring (41)
into spindle groove.
2. Position hub/spindle assembly (36 and 30) with
large open end up.
3. Lower internal gear (21) onto spindle.
4. Place one thrust bearing (16) between two thrust
washers (15) and place them onto spindle pilot.
EYE PROTECTION SHOULD BE WORN DURING RETAINING RING
INSTALLATION.