JLG X550AJ Operator Manual - Manual (Page 129)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3128791 – JLG Lift – 6-27
BMS Fault Codes - (Battery Management
System)
(See “Errors Menu” on page 6-20 info for display information)
NOTE: The CODE column indicates the CAN CODE in the
message sent by the battery charger. The normal
mains voltage tolerance is the rated value ±15%.
CODE – TYPE OF ERROR
A99E01 – Configuration error
A99E02 – Incorrect voltage
A99E03 – Incorrect temperature
A99E04 – Excess discharge current
A99E05 – Excess charge current
A99E06 – Pre.charge error
A99E07 – No 12 V power supply
A99E08 – No 12 V power supply
A99E09 – High battery compartment temperature
A99E10 – High electronic board temperature
A99E11 – Incorrect self.protection device temperature
A99E12 – Fault on all temperature sensors
A99E13 – Temperature sensor fault
A99E14 – Earth connection fault
A99E01 – Incorrect system configuration
A99E02 – Incorrect voltage
A99E03 – Incorrect temperature
A99E04 – Excess discharge current
A99E05 – Excess charge current
A99E06 – Pre.charge error
A99E07 – No 12 V power supply
A99E08 – No 12 V power supply
A99E09 – High battery compartment temperature
A99E15 – Bootloader error
A99E16 – Secondary protection
A99E17 – Control device error
A99E18 – Power board error
A99E19 – I2C module not ready
A99E20 – I2C TX error
A99E21 – I2C RX error
A99E22 – I2C RX error 2
A99E23 – AD error
A99E99 – General error