JLG X550AJ Operator Manual - Manual (Page 93)

SECTION 5 - EMERGENCY PROCEDURES
3128791 – JLG Lift – 5-13
5.4 SAFETY DEVICES BYPASS KEY USE
THIS FEATURE MUST ONLY BE USED AS DESCRIBED BELOW. THE
MACHINE COULD TIP OVER IF THESE DIRECTIONS ARE NOT FOL-
LOWED.
The machine has a key for bypassing the platform safety
systems. The key used to activate the safety device bypass
switch (item 2 - photo), is fastened to the cover attach screw
mounting tab from the factory (item 1 - photo), on the left
side of the electrical components compartment near the bat-
tery.
Remove the key and insert it into the bypass
key switch (item 2 - photo). After using the
safety device bypass, a qualified JLG mechanic
must be contacted to determine the reason for
needing to use this feature. Return the key to the where you
found it and secure it in that location.
The safety device circuit board records every time the safety
device bypass key is activated along with the movements
made during these operations.
THE SAFETY DEVICE BYPASS ALLOWS OPERATION OF THE
MACHINE WITH AN OVERLOAD IN THE PLATFORM. THE OVER-
LOAD ALARM WILL SOUND AND THE OVERLOAD ICON WILL BE
ON THE PLATFORM/REMOTE CONTROL BOX DISPLAY. REMOVE
THE OVERLOAD FROM THE PLATFORM BEFORE OPERATION.
1
2