JLG 800A_AJ ANSI Parts Manual - Manual (Page 230)

3-4 800A 800AJ 3121176
SECTION 3 BOOM
37 0642214 5 Bolt 3/4in-10NC x 1-3/4in
38 0642620 1 Bolt 1in-8NC x 2-1/2in
39 3841340 1 Rod, Hose Loop
40 1120510 1 Cover, Upright
41 1670864 1 Cover, Fly Hose
42 Not Used
43 0961951 2 Bearing, Garmax
44 1 Bolt Options:
0641514 Bolt 5/16in-18NC x 1-3/4in (SN 0300069000 to
SN 0300110181)
0641516 Bolt 5/16in-18NC x 2in (SN 0300110181 to SN 0300140000)
45 1320159 1 Clamp
46 4711500 1 Flatwasher 5/16in Narrow (SN 0300110181 to
SN 0300140000)
47 3311505 1 Locknut 5/16in x 18NC (SN 0300110181 to SN 0300140000)
48 to 49 Not Used
50 3900239 1 Setscrew 3/8in-16NC x 1/2in
0258765 Ref ROTATOR AND SUPPORT INSTALLATION (FRONT ENTRY
PLATFORM) D
101 Use 0060077 1 Rotator Actuator Assembly (was p/n 0060041) (See ROTATOR
ASSEMBLY for Breakdown) (Note: Use p/n 0060069 for
machines equipped with Fall Arrest Platforms.)
102 0100011 AR Compound, Locking
103 0641606 2 Bolt 3/8in-16NC x 3/4in
104 0641608 2 Bolt 3/8in-16NC x 1in
105 0641810 6 Bolt 1/2in-13NC x 1-1/4in
106 0641820 4 Bolt 1/2in-13NC x 2-1/2in
107 0681610 4 Bolt 3/8in-16NC x 1-1/4in (Grade 8)
108 0741607 1 Screw, Countersunk 3/8in-16NC x 7/8in
109 0961951 2 Bearing, Garmax
110 Use 1684408 1 Slave Cylinder Assembly (See CYLINDER SECTION for Break-
down) (was p/n 1683610)
111 3311805 4 Locknut 1/2in-13NC
112 3422578 1 Pin
113 3422580 1 Pin
114 3422582 1 Pin
115 3841143 2 Keeper, Pin
116 3841340 1 Rod, Hose Loop
117 4711600 4 Flatwasher 3/8in Narrow
118 4711800 8 Flatwasher 1/2in Narrow
119 1 Support Weldment Options:
4845703 Standard Machines
See Note Machines with SkyGlazier (Note: Refer to JLG Supplement
p/n 3124242 for Replacement Parts.)
FIGURE 3-1. BOOM AND CYLINDER INSTALLATION - 800A (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.