JLG 800A_AJ ANSI Parts Manual - Manual (Page 31)

3121176 800A 800AJ 1-23
SECTION 1 FRAME
FIGURE 1-6. DRIVE MOTOR ASSEMBLY (ORIGINAL EQUIPMENT) (SN 0300083332 TO SN
0300140000) (4 BOLT ASSEMBLY)
ITEM # PART NUMBER QTY. DESCRIPTION REV.
Ref DRIVE MOTOR ASSEMBLY
3160308 Ref 2WD C
3160266 Ref 4WD C
Ref Note: Original Equipment Motor p/n 3160308 & p/n 3160266
uses 4 bolts to assemble the motor. Service Replacement
Motor p/n 3160347 & p/n 3160348 motors use 5 bolts to
assemble the motor. Visually identify component before
ordering parts. If equipped with p/n 3160347 or p/n 3160348
refer to next illustration.
1 7022302 2 Bearing, Journal
2 Use 7022328 1 O-Ring
3 Use 7022328 1 O-Ring
4 7007446 1 Pin
5 7007438 2 Ring, Retaining
6 1 Swashplate Options:
7024861 2WD
7022305 4WD
7 Use 7022328 1 O-Ring
8 AR Pin Options:
7027435 2 2WD
Not Required 0 4WD
9 1 Cylinder Block Kit (Includes Items 11-19) Options:
7027740 2WD
7023907 4WD
10 1 Plate, Valve Options:
7024862 2WD
7023908 4WD
11 See Note 1 Block, Cylinder (Note: Use Item 51A or 51B.)
12 1 Guide, Slipper Retainer Options:
Use 7027740 2WD
7021277 4WD
13 7021275 3 Pin, Slipper Hold Down
14 9 Piston Assembly Options:
7024865 2WD
Use 7023907 4WD
15 1 Retainer, Slipper Options:
Use 7027740 2WD
7022310 4WD
16 7022311 1 Ring, Retaining
17 1 Spring Options:
7024867 2WD
7022312 4WD
18 1 Washer
7022313 2WD
Use 7023907 4WD
19 7022314 1 Retainer, Spring
20 7023910 1 Shaft
21 7007439 1 Ring, Retaining