JLG 800A_AJ ANSI Parts Manual - Manual (Page 245)

3121176 800A 800AJ 3-19
SECTION 3 BOOM
FIGURE 3-5. ROTATOR ASSEMBLY (FRONT ENTRY PLATFORM)
ITEM # PART NUMBER QTY. DESCRIPTION REV.
Ref ROTATOR ASSEMBLIES
Ref Note: See ROTATOR ASSEMBLY for Machines equipped with
Fall Arrest Platforms.
Ref 800A
0060041 Ref Original Equipment G
0060077 Ref Service Replacement B
Ref 800AJ
0060031 Ref Original Equipment H
1001103095 Ref Service Replacement Kit (contains 0060074 rotator,
upper pin, keeper shaft, keeper shaft bolt & instruction
sheet) 1
Ref Note: Before ordering parts, identify whether original
equipment rotator has been replaced with service replace-
ment. Service replacement rotator uses spacer plate bolted
on the top with 8 capscrews (Not shown - located at item 2).
Original equipment rotator does not use spacer plate.
1 See Note 1 Housing/Ring Gear Assembly (Note: Not Available - Purchase
Complete Assembly.)
2 1 Shaft Weldment Options:
Use 7017177 0060041 & 0060031 Rotators (was p/n 7017117)
7017162 0060077 & 0060074 Rotators
See Note 1 Plate, Spacer (Not Shown) (0060077 & 0060074 Rotators Only)
(Note: Not Available for Purchase.)
3 1 Piston/Sleeve Options:
7017115 0060041 & 0060031 Rotators
7017163 0060077 & 0060074 Rotators
4 1 Cap, End Options:
Use 7017174 0060041 & 0060031 Rotators (was p/n 7017116)
7017164 0060077 & 0060074 Rotators
5 See Note 6 Plug, Port (Note: Not Available for Purchase.)
6 Use 7017142 2 Plug
7 Use 7017119 1 Tie-Rod/Locknut Assy (was p/n 7017102)
7017119 1 Bolt 1in-8NC x 11in
3272605 AR Locknut 1in-8NC
8 Not Used
9 See Note 1 Seal, Cap (Note: Use Item 25)
10 See Note 1 Ring, Back-up (Cap) (Note: Use Item 25)
11 See Note 1 Seal, Rod (Note: Use Item 25)
12 See Note 1 Seal, Piston (Note: Use Item 25)
13 See Note 2 Packing, Bearing (Note: Use Item 25)
14 See Note 1 Bearing, Cap (Note: Use Item 26)
15 See Note 1 Bearing, Shaft (Note: Use Item 26)
16 See Note 2 Washer, Thrust (Note: Use Item 26)