JLG 3969electric ANSI Service Manual - Manual (Page 25)

SECTION 2 - PROCEDURES
3120768 – JLG Sizzor –
2-13
12. The cluster gear can now be removed from the car-
rier). The tanged thrust washer will be removed from
the cluster gear.
13. The needle bearings and thrust spacer are now
removed from cluster gear.
NOTE: When rebuilding or repairing the unit, the retaining
ring (9), o-rings (22), and seal (2) should always be
replaced.
Assembly
1. With the hub shaft sub-assembly resting on the shaft
install internal gear. The spline of the internal gear.
bore will mesh with the spline of the output shaft.
2. Thrust washer (27) is installed on the face of the out-
put shaft. Sufficient grease or petroleum jelly should
be used to hold thrust washer in place.
Figure 2-14. Drive Torque Hub Assembly