JLG 800S Service Manual - Manual (Page 139)

SECTION 3 - CHASSIS & TURNTABLE
3121139 – JLG Lift – 3-93
BECAUSE THE BEARING/BUSHINGS (13) AND (19) HAVE A
PRESS FIT INTO THE HOUSING THEY MUST BE DISCARDED
WHEN REMOVED. THEY MUST NOT BE REUSED.
2. The Torqlink™ inner housing bearing/bushing (13)
can now be pressed into its counterbore in housing
(18) flush to 0.03 inch (.76 mm) below the housing
wear plate contact face. Use the opposite end of the
bearing mandrel that was used to press in the outer
bearing/bushing (19).
3. Press a new dirt and water seal (20) into the housing
(18) outer bearing counterbore.
The Torqlink™ dirt and water seal (20) must be
pressed in until its’ flange is flush against the hous-
ing.