JLG 800S Service Manual - Manual (Page 253)

SECTION 4 - BOOM & PLATFORM
3121139 – JLG Lift – 4-37
Snap Rings and Screws
WHEN PERFORMING MAINTENANCE ON THE POWERTRACK,
MAKE SURE TO DISCARD AND REPLACE ALL OLD SCREWS.
Make sure screws are tight and installed properly.
Make sure that all snap rings are closed and seated.
An open snap ring is shown below.
A snap ring that is not seated is shown below.
A seated and closed snap ring is shown below.
10-24 x 0.812 button torx socket head with blue locking
patch:
• Tighten to 45-50 in.lbs. (5-5.6 Nm).
• Use T-25 torx bit.
• Do not reuse this screw. After removing replace with a
new one.
LOOSE SCREW TIGHT SCREW
CLOSED
OPEN