JLG 800S Service Manual - Manual (Page 84)

SECTION 3 - CHASSIS & TURNTABLE
3-38 – JLG Lift – 3121139
Input Carrier Disassembly
1. Place the Carrier (3A) on a press with the spline end
up and drive the Planet Shaft (3E) out of the Carrier
(3A).
2. Slide the Planet Gear (3F) and the two Thrust Wash-
ers (3B) out of the Carrier (3A).
3. Remove the 14 needle Bearings (3C) from the bore
of the Planet Gear (3F).
4. Repeat steps 1 through 3 for each of the two remain-
ing planet gears.
Figure 3-30. Input Carrier Disassembly
3A. Carrier
3B. Thrust Washers
3C. Needle Bearings
3E. Planet Shaft
3F. Planet Gear