JLG 19BD Service Manual - Manual (Page 31)

SECTION 2 - SERVICE PROCEDURES
3121154 – JLG Lift – 2-9
2.5 MACHINE BOLT DOWN SPECIFICATION
1. Base Weldment 3. Mounting Fasteners
2. Factory drilled .750" (19mm) diameter 4. Solid, firm and level floor surface.
holes in base weldment (4 places) (a)
Notes: (a) Use .500" (13mm) diameter - grade 5 hardware (minimum) with large steel flatwashers. Torque fastener per rating
on torque chart in Section-1 of this service manual.
Figure 2-1. BD - Machine Bolt Down Specifications.
33.000 in.
(83.8
2
c
m
)
18.000 in. (46 cm)
2
2
1
1
4
3