IOGear GWHDMS52 - Manual (Page 11)

8
11
Remote Control
1. POWER ON / POWER OFF Buttons
Press Power ON to turn the Transmitter
& Receiver ON. Press Power OFF to turn
the Transmitter & Receiver OFF. When
both Transmitter & Receiver Power LEDs
are red, press Power ON to the Receiver
to wake-up both the Receiver and
Transmitter automatically.
2. INFO Button
Press this button to the Transmitter or
Receiver to display OSD for system related
information on HDTV.
3. TRANSMITTER NO. Button
Press to switch different transmitter
inputs. Please refer to page 24, Multiple
Transmitter Selection section
4. SOURCE Button
Press to select the audio/video source
inputs to the Transmitter or Receiver.
Press OK to switch to the source input
selected.
5. Up and Down Arrow Buttons
Press to select the audio/video source
inputs for transmitter display. Press OK to
switch to the source input selected.
6. Left and Right Arrow Buttons
Press to select the audio/video source
inputs for receiver display. Press OK to
switch to the source input selected.
7. IR Button
Press to switch the IR Blaster frequency
to meet Source device’s requirement. It
can switch the IR Blaster frequency from
47KHz to 56KHz to 38KHz recurring.
8. Battery Compartment
• Remove the remote control battery
door by pushing the bottom clip in and
lifting on the battery door
• Place the two AAA batteries into the
remote control and replace the battery
door until it snaps in place
1
7
6
5
3
4
2