IOGear GWHDMS52 - Manual (Page 20)

ON
HDMI1 CH1 1280x1024
= OFF
HDMI1 CH1 1280x1024
HDMI1 CH1 1280x1024
= 47KHz
HDMI1 CH1 1280x1024
= 56KHz
20
E. On Screen Display (OSD) vs. Remote Control Instruction
(1) In Active mode, press the POWER
button on the top of receiver or
transmitter or press the remote
control’s Power button and point it
to the receiver or transmitter, both
receiver and transmitter will enter
Standby mode and transmitter’s HDMI
out remains on.
OSD Displays: (Display 3secs and
then enter Standby mode.)
(2) Press the INFO button on the remote
control to display signal quality,
source, channel and resolution
information for user reference. Press
the
INFO button again to exit the
INFO OSD.
OSD Displays:
(3) Press the SOURCE button on the
remote control or on the top of
transmitter (or receiver) for audio/
video source input selection.
OSD Displays:
(4) Press the IR button and then the “Up”
and “Down” keys on the remote control to
change the IR Blaster frequency. The IR
frequency can be switched from 47KHz,
to 56KHz, and to 38KHz recurring. Note
that the IR blaster frequency default
setting is 47KHz.
Press once for current IR frequency status
display.
OSD Displays:
Press IR key again to switch IR blaster
frequency.
OSD Displays: