2N Helios IP Uni v2.1 - Manual (Page 21)

21
2N TELEKOMUNIKACE a.s., www.2n.cz
®
3.1 Configuration
2N
®
Helios IP Uni Use a PC equipped with any web browser to configure:
Launch your web browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the
user name and password. Admin 2n
You have to know the IP address of your device to log in to the integrated web server.
By default,
is switched into the dynamic IP address mode, i.e. it 2N® Helios IP Uni
obtains the IP address automatically if a properly set DHCP server is available in your
LAN. If no such DHCP server is available, you can operate
in the 2N
®
Helios IP Uni
static IP address mode.
If your device remains inaccessible (you have forgotten the IP address, or the LAN
configuration has changed, for example), change the LAN settings using the buttons on
the device.
IP Address Retrieval
Take the following steps to retrieve the IP address: 2N
®
Helios IP Uni
Connect (or, if connected, disconnect and reconnect) to the 2N
®
Helios IP Uni
power supply.
Wait for the second sound signal .
Press the first quick dial button five times.
2N
®
Helios IP Uni will read its IP address.
If the address is 0.0.0.0, it means that the intercom has not obtained the IP
address from the DHCP server.
Static/Dynamic Address Setting Mode Switching
In case your device is equipped with 1 or 2 buttons, you can 2N
®
Helios IP Uni
switch the modes using one button only.
Connect to the power supply (or, disconnect and reconnect it 2N
®
Helios IP Uni
if already connected).
Wait for the first acoustic signal .
Press button 1 fifteen times.
The acoustic signal indicates mode switching.
Wait until the device is restarted automatically.
Note
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.