2 electric installation, Description of printed circuit board connectors – 2N Helios IP Vario User Manual
Page 22
22
2.2 Electric Installation
2N
®
Helios IP Vario is designed for connection in the Ethernet computer network
(10/100BASE-T) using a UTP cable. Use a CAT 5e UTP cable at least for connection.
is fed through the PoE (Power over Ethernet) technology. No
2N
®
Helios IP Vario
additional cabling is therefore necessary. If your Ethernet is not equipped with the PoE
technology, it is possible to use a PoE injector, Part No. 91378100. As an alternative,
you can use a power adapter, Part No. 91341481E.
is configured
2N
®
Helios IP Vario
over an integrated administration web server, which can be controlled from any web
browser, e.g., Mozilla Firefox.
Description of Printed Circuit Board Connectors
In
you can see the location of the printed circuit board (PCB) connectors.
Figure 2.11
Connectors to which the accessories can be connected and connectors that serve for
configuring
are indicated on the board. The UTP cable for the
2N
®
Helios IP Vario
Ethernet connection is to be connected to the terminal block X2 as shown in
.
Table 2.1
The terminal block can be removed from the PCB. The connection of each of the
connectors is described in the subsections below.
Figure 2.11 Description of Connectors, PCB Version 530v2