ADS-TEC OPC7008 - Manual (Page 23)

Industrial PCs OPC7008
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-E
6.4 PS/2 CONNECTOR
A keyboard can dire
PIN NUMBER
1
2
3
4
5
6
Note:
Since the timing of
keyboards of this m
If the soft keyboard
for control purpose
The keyboard must
interface is initialise
device is running w
functional.
Pos : 30 /D atent ec hni k/Schnitts tell en/Netz werkansc hlus s RJ 45/Netz wer kansc hluss RJ 45 für O PC / IPC / C PC / PLC / OTC / ITC / VMT-Serie/ LSI 5015 SEW @ 0\ mod_1158924094127_6. doc @ 549 @
6.5 N ETWORK CONNECTION
If the drivers requir
be integrated in an
Ethernet 10/100Bas
observed in this cas
the enclosed service
PIN NUMBER
1
2
3
4
5
6
7
8
Pos : 31 /D atent ec hni k/Schnitts tell en/Seriell e Schnitts tell e C OM RS232/Serielle Sc hnitts tell e C OM (RS232) f ür OPC / I PC / C PC / PLC / OTC / ITC / VMT / M SA- Serie @ 1\ mod_1249303286408_6. doc @ 6104 @
Echterdingen
ectly be operated by using the PS/2 socket connec
SIGNAL NAME
Keyboard data
Mouse data
GND
+5V
Keyboard clock
Mouse clock
f the integrated controller is specifically set up for
manufacturer should preferably be used.
rd is actively displayed on the monitor, the use of
es is limited.
st be connected before switching the device on, b
sed in the process of booting. If the keyboard is p
without having had the keyboard connected while
N (RJ45)
red for functioning are installed on the device, th
Ethernet network supporting the 10/100 Mbit
seT network connector. Specifications of this netw
se. You can install the drivers required for the
e CD, should they not be installed on the device.
SIGNAL NAME
TX +
TX -
RX +
NC
NC
RX -
NC
NC
23
ctor.
r Cherry keyboards,
f the external keyboard
because the keyboard
plugged in while the
e booting, it will not be
he control system may
standard by using the
work topology must be
network function from