ADS-TEC IF1000 User Manual
Page 28
IF1000 series
27
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
Device info
Anzeige
Selection
Action
Device info
This option displays general device
information.
The screen shows the name of the
manufacturer, the device variant, whether
a NVRAM card is installed, the current
firmware version, and the current firmware
build.
Device Test
Anzeige
Selction
Action
Screen
Starts the display test.
Press Enter to start the display test.
Perform this test to check the display for
correct functioning. You can visually check
whether all characters are displayed
properly on the display.
Four different test screens will appear, each
of which will need to be confirmed by
pressing any front panel key.
When the test is finished, you will
automatically be taken back to the menu
view.
Keys
Starts the key test.
Press Enter to start the key test.
Perform this test to check the keys for
correct functioning.
You will be prompted to press specific keys,
whereupon you should press the respective
key.
In case one key is defective, you may exit
the test using the other keys.
When the test is finished, you will
automatically be taken back to the menu
view.
Alarm
Sets the alarm output.
Sets the alarm output and turns on the
alarm LED.
The letters AL will appear in the upper right
corner of the display, indicating that an
alarm was triggered. AL will continue to
flash until the alarm is either switched off
or acknowledged automatically.
Perform this test to check the alarm output
for correct functioning.