AirLive BC-5010-IVS - Manual (Page 13)

2. Package Contents and Installation
AirLive BC-5010/BC-5010-IVS User’s Manual 8
1. RJ45 LAN socket: Connect to PC or Hub/Switch.
This Ethernet port built N-Way protocol can detect or negotiate the transmission speed of
the network automatically. Please use Category 5 cable to connect the Network Camera
to a 100Mbps Fast Ethernet network switch or hub.
In the LAN socket, there are two LEDs below:
LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
Power (orange color)
This LED is used to indicate whether DC power is on or not. In addition, this LED will
be flashing while the wireless accessing of the Camera.
2. GPIO/RS-485: Connect to a local keyboard controller.
„ DI/ DO: Connect to sensor in and alarm out devices
Cable for I/O connectors:
PIN SPECIFICATION
1 RS-485 D+
2 RS-485 D-
Compliant to RS-485
3 Ground (Common) GND
4 GPIO Out
Close circuit current maximum: 70mA AC or 100mA
Output resistance: 30 ohm
Open circuit voltage maximum: 240V AC or 350V DC
5 GPIO In #1
6 GPIO In #2
Action high voltage: 9~40 VDC
Dropout voltage: 0 VDC
3. DC-in Jack: The input power is DC 12V/1A.
Note that supply the power to the Network Camera with the power adapter included in
package.
4. Audio I/O Connectors
„ MIC in (audio in): Connect a microphone to the network camera.
„ Audio out: Connect a loud speaker to the network camera. This function is for
voice alerting and two-way audio.
5. Iris Level: It is used only when the DC-Iris lens is connected to the camera. This
screw-knob allows you to adjust the brightness of the video images from the DC-Iris lens.