AirLive BC-5010-IVS User Manual
Page 16
2. Package Contents and Installation
AirLive BC-5010/BC-5010-IVS User’s Manual
11
3. Connect the external power supply to Camera
Connect the attached power adapter to the DC power jack of the camera.
Note: Use the 12VDC power adapter, included in the package, and connect it to wall
outlet for AC power.
Once you have installed the camera well and powered it on, the power LED (orange) will
turn on later. When the power LED turned on, it means that the system is booting up
successfully. Furthermore, if you have a proper network connection and access to the
camera, the LAN LED (green) will flash.
4. Replacing the Lens Assembly
The camera is designed with a CS- mount, allowing you to install any standard C or CS
lens that are commonly used in the surveillance application.
Installing the Lens Assembly
To install new lens assembly, follow the instructions below:
1. Remove the protective cap.
2. Fit the C or CS lens onto the CS-mount ring and screw it in clockwise.
3. Plug the cable to the DC-Iris connector on the side panel of the camera.
When you use a DC-Iris lens on your camera, you can adjust the brightness of the
video image through the Iris Level screw-know on the back panel of the camera.