AirLive CamPro Express 64 - Manual (Page 45)

44
„ Channel Table: Select the desired channel for setting the motion
detection area.
„ Start: Use this check box to determine whether to turn on the motion
detection function.
„ Sensitivity: Set the sensitivity level of the motion detection.
„ Trigger Source: Select the trigger source. If the user sets this value to
Server, CamPro Express 64 will detect the motion by itself. On the
other hand, if this value set to Camera, the detection task will be taken
by the IP camera side. Once the motion is detected, the IP camera will
send message to CamPro Express 64 for alerting the software to start
recording.
„ Live View Window: Just click on the mouse and drag the detection
area over the Live View window. The defined area will show in green
over the Live View window. You might also right click on the green gird
for cancel the very grid you selected.
„ Button: Clear the motion detection area setting if you needed to
redefine the detection area.