AirLive CU-720PIR - Manual (Page 84)

5. Troubleshooting & FAQ
79 AirLive CU-720PIR User’s Manual
• If you are using the default camera port settings, enter 80 into the Public and Private
Port section, click Apply.
• Scheduling should be set to Always so that the camera images can be accessed at any
time.
A check mark appearing before the entry name will indicate that the ports are enabled.
Important: Some ISPs block access to port 80. Be sure to check with your ISP so that
you can open the appropriate ports accordingly. If your ISP does not pass traffic on port 80,
you will need to change the port the camera uses from 80 to something else, such as 8080.
Not all routers are the same, so refer to your user manual for specific instructions on how to
open ports.
Enter valid ports in the Virtual Server section of your router. Please make sure to check
the box on this line to enable settings. Then the device can be access from WAN by the
router’s WAN IP Address.
By now, you have finished your entire PC configuration for this device.