AirLive DS-100 v2 User Manual
Page 32
Advertising
5. Troubleshooting
AirLive DS-100 v2 User’s Manual
29
Fig. 2-1 (for 3-pole)
Fig. 2-2 (for 2-pole)
Step 2.
Plug in the DC power into the left position hole
of STB-male connector, as shown in Fig 2-1 &
Fig.2-2
Fig.3-1
Fig. 3-2
Step 3.
Tighten up the screw on top of the STB-male
connector, makes sure the DC
Step 4.
Insert the STB-female connector to the rear
side of device, as shown in Fig. 3-1 and Fig.
3-2.
*Note:
* Check the DC power apply to DTB connector fist, makes sure the DC power is
Advertising