AirLive Ether-FSH2422W - Manual (Page 12)

AirLive Ether-FSH2422W User’s Manual
6
2-5 Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby. The surface where the user
put the switch should be clean, smooth, level and sturdy. Make sure there is enough clearance around
the switch to allow attachment of cables, power cord and allow air circulation.
2-5-1 Attaching Rubber Pads
A. Make sure mounting surface on the bottom of the switch is grease and dust free.
B. Remove adhesive backing from your Rubber Pads.
C. Apply the Rubber Pads to each corner on the bottom of the switch. These footpads can
prevent the switch from shock/vibration.
2-6 Rack-mounted Installation
The Ether-FSH2422W comes with a rack-mounted kit and can be mounted in an EIA standard size,
19-inch Rack. The switch can be placed in a wiring closet with other equipment.
Perform the following steps to rack mount the switch:
A. Position one bracket to align with the holes on one side of the switch and secure it with the
smaller bracket screws. Then attach the remaining bracket to the other side of the switch.
B. After having attached mounting brackets, position the Ether-FSH2422W in the rack by lining
up the holes in the brackets with the appropriate holes on the rack. Secure the switch to the
rack with a screwdriver and the rack-mounting screws.
[NOTE] For proper ventilation, it allows about at least 4 inches (10 cm) of clearance on the front and
3.4 inches (8 cm) on the back of the Switch. This is especially important for enclosed rack installation.
2-7 Power On
Connect the power cord to the power socket on the rear panel of the Switch. The other side of power
cord connects to the power outlet. The internal power supply of the Switch works with voltage in the
range of 100-240V
AC
and Frequency of 50~60Hz. Check the power indicator on the front panel to see if
power is properly supplied.