AirLive FE-200VD - Manual (Page 50)

5. Appendix
AirLive FE-200VD Manual 44
The username and
password for the first
time or after factory
default reset Username = admin and Password = airlive.
Note that it’s all case sensitivity.
Forgot the username
and password Follow the steps below.
1. Unplug the power jack to turn off the camera
2. Short pin 5 and pin 6 with a wire
3. Plug in the power jack to turn on the camera. The
power LED will start flashing in a short while.
4. Break the short when the LED starts quick flashing.
Wait for a few minutes the device should be set back to
factory default.
5. Default IP address is 192.168.1.100.
Username/Password is admin/airlive.
Forgot the IP address
of the device. Check IP address of device by using the IPWizard II
program or by UPnP discovery.
IPWizard II program
cannot find the device. • Re-power the device if cannot find the unit within 1
minutes.
• Do not connect device over a router. IPWizard II
program cannot detect device over a router.
• If IP address is not assigned to the PC which running
IPWizard II program, then IPWizard II program cannot
find device. Make sure that IP address is assigned to
the PC properly.
• Antivirus software on the PC might interfere with the
setup program. Disable the firewall of the antivirus
software during setting up this device.
• Check the firewall setting of your PC or Notebook.
Internet Explorer does
not seem to work well
with the device Make sure that your Internet Explorer is version 6.0 or
later. If you are experiencing problems, try upgrading to
the latest version of Microsoft’s Internet Explorer from
the Microsoft webpage.
IPWizard II program
fails to save the
network parameters. • Network may have trouble. Confirm the parameters
and connections of the device.