AirLive FE-200VD - Manual (Page 9)

1. Introduction
AirLive FE-200VD Manual 3
1.3 Connections
1. RJ45 LAN socket:
Connect to PC or Hub/Switch via a 10Base-T Ethernet or 100Base-TX Fast Ethernet cable.
This Ethernet port built with N-Way protocol can detect or negotiate the transmission
speed of the network automatically. Please use Category 5 cable to connect the Network
Camera to a 100Mbps Fast Ethernet network switch or hub.
In the LAN socket, there are two LEDs embedded:
LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
Power (orange color)
This LED is used to indicate whether DC power is on or not. In addition, this LED will
be flashing while the wireless accessing of the Camera.