AirLive IAS-2000 v2 - Manual (Page 12)

IAS-2000 v2
User’s Manual
. 5
Chapter 3. Hardware Installation
3.1 Panel Function Descriptions
Front Panel
LED Color Status Description
POWER Green On Power on the device
Off BIOS running
Blink OS running Status LED Green
On System ready
WAN1, LAN1,
WAN2, LAN2
(L)
Orange Blink Sending / Receiving
Off 10 Mbps
Green
On 100 Mbps
WAN1, LAN1,
WAN2, LAN2
(R) Orange On 1000 Mbps
Port Description
WAN1 / WAN2 Connect to Internet or Intranet
LAN1 / LAN2
Connect to the open environment. It can be chosen to require authentication to
access network resources and Internet.
Console Port
9-pin serial port connector to resume the factory defaults or reconfigures the
system.
Panel Button LCD Panel to display system info and network interface info
LED: There are four kinds of LED, power, status, port speed and link/act, to indicate different status of the system.
Console Port: The system can be configured via HyperTerminal. For example, if you need to set the Administrator’s
Password, you can connect a PC to this port as a Console Serial Port via a terminal connection program (such as
the super terminal with the parameters of 9600, 8, N, 1, None flow control) to change the Administrator’s Password.
LAN1/LAN2: The two LAN ports can be independently configured such that users cannot access Internet before
authentication. Thus, administrators can choose to force the authentication for users connected to these ports.
WAN1/WAN2: The two WAN ports are connected to a network which is not managed by the IAS-2000 v2 system,
and this port can be used to connect the ATU-Router of ADSL, the port of Cable Modem, or the Switch or Hub on the
LAN of a company.