AirLive IAS-2000 v2 - Manual (Page 54)

IAS-2000 v2
User’s Manual
. 47
¾ Enable: Enable this VLAN segment.
¾ Enable User Authentication: Choose to enable or disable user authentication for this individual VLAN
segment.
¾ VLAN Tag: Enter any integer number within the range of 2~4094 as the Tag for this VLAN segment.
¾ Mode: Two modes are provided: NAT mode and ROUTER mode.
‹ NAT: All IP addresses externally connected through the VLAN port (these IP addresses must belong
to the same network of the VLAN port) will be converted into the IP address of the WAN1 port
by IAS-2000 v2 and onward to outside the network.
‹ Router: All IP addresses externally connected through the VLAN port use its original IP addresses
for external connection. Thus, IAS-2000 v2 acts like a Router.
¾ IP Address: Enter the desired IP address for this VLAN.
¾ Subnet Mask: Enter the desired Subnet Mask for this VLAN.
y
VLAN DHCP Configuration
¾ Disable DHCP Server: Disable the function of the DHCP Server of IAS-2000 v2.
¾ Enable DHCP Server: If you want to use the DHCP Server function of IAS-2000 v2, set proper
configurations is necessary. Related information needed on setting up the DHCP Server is described as
follows: Start IP Address, End IP Address, Preferred DNS Server, Alternate DNS Server, Domain Name,
WINS Server, Lease Time, and Reserved IP Address List. See the following figure.