AirLive IP-200PHD - Manual (Page 10)

1. Introduction
9
AirLive IP-200PHD User’s Manual
3. Factory Default Reset
This button is hidden in the pinhole. This button is used to restore the all
factory default settings. Sometimes restarting the camera will make the
system back to a normal state. If the system still got problems after restart,
user can restore the factory default settings and install it again. To restore
the device, please follow the steps below:
(1) Insert the paper clip or other tool and press and hold the button down
continuously.
(2) Hold it at least 5 seconds and release the tool. Then the device has been
restored to default settings and reboot again.
Note: Restoring the factory default setting will lose the all previous settings
included IP address forever. User needs to run the IPWizard II program to
search the device and configure it to let the device work properly again.
4. LAN Socket
The LAN socket is a RJ-45 connector for connections to 10Base-T Ethernet
or 100Base-TX Fast Ethernet cabling. This Ethernet port built N-Way
protocol can detect or negotiate the transmission speed of the network
automatically. Please use Category 5 cable to connect the Network
Camera to a 100Mbps Fast Ethernet network switch or hub.
5. LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
6. Power LED (orange color)
This LED is used to indicate whether DC power is on or not.
1.6 Hardware Installation
1. Attach the Camera with the included stand
2. Place the Camera on the table or fix it onto ceiling or wall
Use three screws to fix the Network Camera onto the ceiling or wall. You could
also put the Network Camera on the table directly.