AirLive N.Power - Manual (Page 19)

3. Configuring the N.Power
AirLive N.Power User’s Manual
14
To prepare your PC for management with the N.Power, please do the following:
1. Connect your PC directly to the LAN port on the DC Injector of N.Power
2. Set your PC’s IP address to “Obtain an IP address Automatically”. The N.Power
should provide your PC a valid IP address.
3. If you want to set your PC’s IP address manually, please set to 192.168.1.50 (or other
address in the same subnet)
You are ready now to configure the N.Power using your PC.
3.3 Introduction to Web Management
The N.Power can be configured using the Web management interfaces by simply typing its
IP address in the web browser. Most functions of N.Power can be accessed by it.
If you are placing the N.Power behind router or firewall, you might need to open the port 80
at virtual server on your firewall/router. This procedure is not necessary in most cases
unless there is a router/firewall between your PC and N.Power.
3.3.1 Getting into Web Management
To get into the Normal Web Management, simply type in the N.Power’s IP address (default
IP is 192.168.1.254) into the web browser’s address field.
50