AirLive PoE-2600HD - Manual (Page 98)

5. Appendix
AirLive PoE-2600HD/
WN-2600HD User’s Manual 94
(1) Assign a local/fixed IP address to your device
The device must be assigned a local and fixed IP Address that allows it to be recognized
by the router. Manually setup the device with a fixed IP address, for example,
192.168.0.100.
(2) Access the Router with Your Web browser
The following steps generally apply to any router that you have on your network. The
D-Link DI-624 is used as an example to clarify the configuration process. Configure the
initial settings of the router by following the steps outlined in the router’s Quick
Installation Guide.
If you have cable or DSL service, you will most likely have a dynamically assigned WAN IP
Address. ‘Dynamic’ means that your router’s WAN IP address can change from time to
time depending on your ISP. A dynamic WAN IP Address identifies your router on the
public network and allows it to access the Internet. To find out what your router’s WAN IP
Address is, go to the Status screen on your router and locate the WAN information for
your router. As shown on the following page the WAN IP Address will be listed. This will be
the address that you will need to type in your web browser to view your camera over the
Internet. Be sure to uncheck the Reset IP address at next boot button at the top of the
screen after modifying the IP address. Failure to do so will reset the IP address when you
restart your computer.
Your WAN IP Address will be listed here.